Tweet
Since a few days te dimming characteristics in Loxone seem to have change - all dimmers must be configured 15% higher than before to get the same level of licht (ligts must be set to 20% minimum to even start producing light). This is the case both for Loxone branded spots and for LED strips and other LED light sources. There is no impact on 0-10V dimmers, but all my Loxone DMX PWM dimmers are affected.
I have upgraded all lighting blocks to smartactors about half a year ago in order to get a more fluent dimming characteristic, but with this recent change, the dimming range is significantly reduced and therefore dimming is less fluent.
There's nothing changed in my config, tension of power supplies is unchange (232V AC input and exactly 24,0V DC output, both under load and idle). I suspect there has been a firmware upgrade of the DMX extension or the dimmers. Anyone else experiencing the same ? Any idea what the real cause can be ?
I have upgraded all lighting blocks to smartactors about half a year ago in order to get a more fluent dimming characteristic, but with this recent change, the dimming range is significantly reduced and therefore dimming is less fluent.
There's nothing changed in my config, tension of power supplies is unchange (232V AC input and exactly 24,0V DC output, both under load and idle). I suspect there has been a firmware upgrade of the DMX extension or the dimmers. Anyone else experiencing the same ? Any idea what the real cause can be ?